2
The Warmset Wall Heating System is an electrical appliance
and must be installed in accordance with the IEC
(International Electrotechnical Commission). It complies with
the laws
EN60335-1 EN60335-20 EN50366
These instructions are available in digital format on the site
www.warmset.com
Dear Customer, Thank you for choosing
this Warmset product
The wall heating panel
Warmset
is an electrical device
.
It is very
important to read carefully these instructions before the use
.
For
any other information contact
Warmset Srl.
Keep this manual
with you and never entrust the panel to other peeople without
giving this instruction paper.
What is included
:
•
Wall heating panel
•
Template for tracing holes in fixing elements
•
Fixing system: a male bar-hook to be applied to the panel
(vertical or horizontal), female hook bar to be applied to the
wall, bar with magnets to be applied to the wall, 4 plugs and
4 fisher
.
The Warmset
heating
panel is built to heat indoor environments
through radiation, not to use it for other purposes. Any other use
may cause damage to the panel and damage to people, animals
or things. In no case should it be covered with clothes or fabrics
in general
.
The Warmset heating panel is an electric heating system by radiation,
which uses the Joule effect of the conductor inside (patented Warmset
system) to radiate heat. The panel converts all electricity into thermal
energy.
It has a setting time of a few minutes, based on the temperature of the
environment where it works. To reach the desired room temperature it
is recommended that the panel remains on for as long as necessary
once it reaches the operating temperature.
All the panels contain a thermal protector at 120 ° C which temporarily
blocks its operation in the event of overtemperature.
Product information
General
panel
informations
