background image

3

All  the  Warmset  heating  panels  must  be  used  only  as  heating 
elements,  both  primary  and  not-primary;  any  other  use  of  the 
product  can  lead  to  significant  damage  to  people,  animals  and  the 
environment. 
Warmset 

heating

  panels  are  not  designed  to  be  used  by 

people with  reduced  physical,  sensory  or  mental  abilities,  or  with 
lack  of experience  or  knowledge,  unless  they  are  supervised  by  a 
person responsible  for  their  safety,  or  have  received  adequate 
instructions on  the  use  of  the  device. 
All  heating  panels  must  be  kept  out  of  the  reach  of  children.  It  is 
recommended  to  supervise  the  children  to  make  sure  that  they  do 
not  play  with  the  device.  Warmset  heating  panels  are  not  suitable 
for  outdoor  use  in  the  rain  or  in  permanently  wet  conditions,  under 
water  and  for  any  other  use  not  specified. 
All  the  heating  panels  are  equipped  with  a  thermal  protector  at  120 
°  C  which  temporarily  blocks  operation  in  the  event  of  overheating 
(for  example  in  the  event  of  accidental  covering  of  it).

Don't  cover  the  panel

.

The panel heats

 (

max Temp.

 95° C). 

It can cause skin burns in case

 

of prolonged contact

Each panel is equipped with a plug mod. Shuko. Using a specific

 

adapter it is possible to integrate it with a room temperature

 

control.

NEVER use the panel when the plug cable is damaged. Check this

 

before each use. Do not remove the plug by pulling on the cable;

 

may cause it to tear. Be careful not to rub the cable on sharp

 

edges. In the event of damage, contact Warmset Srl.

NEVER immerse the 

heating

 panel in water.

In the event of damage to the panel or the mains, immediately

 

disconnect the panel from the power supply.

NEVER open the device to avoid damage and accidents. The

 

device can be open by authorized personnel. Failure to do so will

 

void the warranty

General warnings before the use

General 
security 
informations

Special 
Security

 

Informations

01

Summary of Contents for WHP









Reviews: