Warmup 2WHP1.0, Installation Manual

11

Using a permanent marker, mark out the areas on the wall surface where the 

heated zones will be. ONLY install the wall heating panel in these marked zones.

Mark the positions and planned route of the power lead cables as well as the 

temperature sensor.

Test the heating panel using the method described on page 6

Start by installing the panel in the location closest to 

the thermostat. You will need to staple the mesh to 

the wall to hold the heating panel in place.

Always take care not to damage the heating cable 

when stapling the mesh to the wall. Never staple the 

heating element wire as this may result in damage. 

Roll out the heating panel along the wall following 

the planned route of the zones to be heated. If the 

panel needs to be cut and turned ,before you reach 

the point where the panel will be turned, remove 

the film from the tape and fix the first section of the 

panel to the wall. 

N.B DO NOT cut the wire. 

Additional staples may be used to help hold the 

panel flat. Continue installing the heating panel using 

this method. 

DO NOT let the heating element cross or touch at any 

time.

Depending on the requirements of the tiler, it may 

be necessary to chisel out or “chase” short channels 

in the wall surface to minimise the increased height 

presented by the power cable, the end joint and the 

floor probe.

Fit the power supply cable into the channels and secure with fixing tape or suitable 

cable clips. 

NOTE:

 Do 

NOT 

cover the joints with tape as air pockets will cause the heater to fail. 

Ensure that all joints are completed embedded in adhesive. 

Wall Heater installation