Warmup 2WHP1.0, Installation Manual

3

Pr

oduct Description 

Warmup Electric Wall Heating Panel for Professional Installation ONLY.

The Warmup Electric Wall Heating Panel is a flexible sheet heating element which 

complies with The Electrical Safety Regulations 1994. This product is designed for 

installation behind tiles or natural stone, within walls, to provide radiant heat either 

for small areas of a wall or for whole room heating. 

Note: For whole room heating it is advised that a heat loss calculation is carried out 

to determine that the size and overall wattage of the heating system is adequate.

This product must be installed by a professional in strict accordance with the 

manual and “signed off” by a qualified and certified electrician to ensure that it 

complies with The Electrical Safety Regulations 1994. ALL documentation and 

information specified and requested within the manual must be recorded and 

provided to the “end user”.

This product must be used in conjunction with the materials specified within the 

manual and be controlled by a thermostat with limiting sensor in accordance with 

EN 60364-4-42. The system MUST be supplied by a 30mA RCD.

The heating wire has been pre-spaced to ensure that spacing be kept constant to 

ensure that wattage density across the whole panel is uniform. The wire should not 

be removed from the mesh.

The product is designed for a single wall and should not be extended across 

multiple walls or to floor or ceiling surfaces. The heating wire should be place on 

a single flat surface and must not be bent or creased across the wall surface. It is 

essential that ALL wall areas that are heated OR not heated must be marked on a 

diagrammatic plan. No fixings or insulative materials should be applied to walls 

in heated areas. The heating systems must NOT be placed over water pipes or 

other electrical systems. The heating system must not be placed near to or against 

flammable materials.

Failure to comply with the instruction manual may result in the product not being 

in compliance with the relevant safety standards, being deemed unsafe, and will 

result in the product warranty and guarantees being invalidated.