36
Warranty
The
Warmup StickyMat 3D™ system is guaranteed by
Warmup plc (“Warmup”) to be free from defects in
materials and workmanship under normal use and
maintenance, and is guaranteed to remain so subject
to the limitations and conditions described below� The
StickyMat 3D™ system is guaranteed for the LIFETIME of
the floor/wall covering under which it is fitted except as provided below
(and your attention is drawn to the exclusions listed at the end of this
guarantee)�
This lifetime guarantee applies:
1.
Only if the unit is registered with Warmup within 30 days after purchase�
Registration can be completed online at www�warmup�co�uk� In the event
of a claim, proof of purchase is required, so keep your invoice and receipt
- such invoice and receipt should state the exact model that has been
purchased;
&
2.
Only if the heater has been earthed and protected by a Residual Current
Device (RCD) at all times�
The guarantee is void if the floor or wall covering over the heater(s) is
damaged, lifted, replaced, repaired or covered with additional layers�
The guarantee period begins on the date of purchase� During the period
of the guarantee Warmup will arrange for the heater to be repaired or (at
its discretion) have parts replaced free of charge� The cost of the repair
or replacement is your only remedy under this guarantee which does not
affect your statutory rights�
Such cost does not extend to any cost other than direct cost of repair
or replacement by Warmup and does not extend to costs of relaying,
replacing or repairing any floor/wall covering or floor/wall� If the heater
fails due to damage caused during installation or tiling, this guarantee
does not apply� It is therefore important to check that the heater is
working (as specified in the installation manual) prior to tiling�
WARMUP PLC SHALL IN NO EVENT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO EXTRA
UTILITY EXPENSES OR DAMAGES TO PROPERTY�
WARMUP PLC is not responsible for:
1.
Damage or repairs required as a consequence of faulty installation or
application�
2.
Damage as a result of floods, fires, winds, lightening, accidents, corrosive
atmosphere or other conditions beyond the control of Warmup plc�
3.
Use of components or accessories not compatible with this unit�
4.
Products installed outside the United Kingdom�
5.
Normal maintenance as described in the installation and operating
manual, such as cleaning thermostat�
6.
Parts not supplied or designated by Warmup�
7.
Damage or repairs required as a result of any improper use, maintenance,
operation or servicing�
8.
Failure to start due to interruption and/or inadequate electrical service�
9.
Any damage caused by frozen or broken water pipes in the event of
equipment failure�
10.
Changes in the appearance of the product that does not affect its
performance�
