3
Pr
oduct Description
Warmup Electric Wall Heating Panel for Professional Installation ONLY.
The Warmup Electric Wall Heating Panel is a flexible sheet heating element which
complies with The Electrical Safety Regulations 1994. This product is designed for
installation behind tiles or natural stone, within walls, to provide radiant heat either
for small areas of a wall or for whole room heating.
Note: For whole room heating it is advised that a heat loss calculation is carried out
to determine that the size and overall wattage of the heating system is adequate.
This product must be installed by a professional in strict accordance with the
manual and “signed off” by a qualified and certified electrician to ensure that it
complies with The Electrical Safety Regulations 1994. ALL documentation and
information specified and requested within the manual must be recorded and
provided to the “end user”.
This product must be used in conjunction with the materials specified within the
manual and be controlled by a thermostat with limiting sensor in accordance with
EN 60364-4-42. The system MUST be supplied by a 30mA RCD.
The heating wire has been pre-spaced to ensure that spacing be kept constant to
ensure that wattage density across the whole panel is uniform. The wire should not
be removed from the mesh.
The product is designed for a single wall and should not be extended across
multiple walls or to floor or ceiling surfaces. The heating wire should be place on
a single flat surface and must not be bent or creased across the wall surface. It is
essential that ALL wall areas that are heated OR not heated must be marked on a
diagrammatic plan. No fixings or insulative materials should be applied to walls
in heated areas. The heating systems must NOT be placed over water pipes or
other electrical systems. The heating system must not be placed near to or against
flammable materials.
Failure to comply with the instruction manual may result in the product not being
in compliance with the relevant safety standards, being deemed unsafe, and will
result in the product warranty and guarantees being invalidated.
Summary of Contents for WHP1
Page 17: ...17 Wall Plan ...
