Warmup WHP1, Installation Manual

8

Important Installation Points 

ALWAYS 

 plan the installation and complete the relevant documentation provided 

in this instruction manual. It is important that this is placed near or at  the consumer 

unit so that the end user has all the information needed for the Wall Panel Heating 

system. 

ALWAYS

 ensure  that all electrical work, testing and diagrams of the installation 

have been signed off by a certified electrician .

ALWAYS  

test the heating panel before, during and after the final installation. This is 

very important during the tiling stage and after any fixings have been made to the 

wall. 

ALWAYS

 take care during installation not to damage the heating wire.

ALWAYS 

installed the heating panel at least 50mm from conductive parts of the 

building. 

ALWAYS 

ensure that a heat loss calculation have been carried out and all heating 

requirements have been met if the system is to be used as a primary source of heat.

ALWAYS 

advise other trades of the location of the heating panels before the 

commence any work to avoid damage to the heating panel.  They should be made 

aware of all the heated and unheated zones. Placing  temporary warning labels 

within the  heated areas will reduce the risk of damage. 

ALWAYS

 leave a perimeter of 200mm around the edge wall. This will reduce the risk 

of the heating panel sitting above other electrical circuits located behind the wall. 

ALWAYS 

fix the heating panels to cementitous non flammable materials or to a 

board fit for purpose such as a Tile backer board with a euroclass “E” rating.