Operating Instructions
Warning
Shock Hazard
Failure to observe these instructions could lead to severe injury or death
.
Always use properly grounded 120V AC receptacle protected by a ground fault circuit
interrupter (GFCI).
Never remove ground pin from plug.
Never operate this AC product in a wet environment.
Never route electrical cables across sharp edges.
Never route electrical cables through or near moving parts.
Always read and follow all wiring instructions included in operators guide.
Always insulate and protect all exposed wiring and electric terminals.
CAUTION
Personal Injury Hazard
Failure to observe these instructions could lead to minor or moderate injury.
Always wear leather gloves when handling wire rope
Never spool out past the length of red rope.
Warning
Moving Parts Entanglement Hazard
Failure to observe these instructions could lead to severe injury or death
.
ALWAYS keep hands clear of the wire rope, hook loop, hook and fairlead opening
during installation, operation and when spooling in or out.
ALWAYS use supplied hook strap whenever spooling the wire rope in or out, during
installation, or operation to avoid injury to hands or fingers.
Connect the PullzAll to an AC power source
Connect the winch power cord to a properly grounded, 3-prong electrical socket with a Ground Fault Circuit
Interrupter (GFCI).
Verify that all wiring and power supply cord are positioned so that the wire rope or moving load will not
damage the cord.
If using an extension cord and/or generator, make sure that it is rated to handle the current required to run
at full capacity.
Always unplug the product while rigging, when not in use, or during maintenance & cleaning.
PAGE 7
74565 Rev. A1
RED
