WARN INDUSTRIES
PAGE 4
84856A0
III. Rubicon & Foreman Installation
1. Begin by removing the front skid plate located on
the front of the ATV. Remove the four side 8mm
bolts and four bottom 6mm bolts securing the front
skid plate, figure 1. Save the fasteners as they
will be used later to reinstall the front skid plate.
2. Remove the four plastic rivets on each side of
the front plastic fascia, figure 2. Use a large
screw driver to carefully remove the center rivet.
After removing the center rivet, remove the rivet
housing. Save the fasteners as they will be used
to reinstall the front plastic fascia.
3. Remove the two 6mm bolts that attach the front
plastic fascia to the bumper, figure 3. Remove the
front plastic fascia at this time.
Figure 1 Remove Front Skid Plate
Remove
Remove
Remove
Skid Plate
Figure 2 Remove the Four Plastic Rivets
Remove
(both sides)
Remove
(both sides)
Figure 3 Front Plastic Fascia Bolts
Remove (both sides)
