PROGRAMMING THE RECEIVER
The hand held remote (transmitter) is programmed from the
factory to communicate with your specific receiver. Under
normal circumstances programming will not be necessary.
However, any replacement remote must be programmed to
communicate with your receiver. Use the following procedure:
1. Insure the system is properly installed and connected.
2. Turn the ATV ignition key to ON.
3. Activate the system by pressing and holding both buttons
until the GREEN LED lights up.
4. Press and hold the receiver programming button for at least
five (5) seconds until the RED LED on the receiver lights up
and stays on.
5. Release the programming button.
6. Press the power IN button on the remote for at least one
(1) second until the RED LED on the receiver turns off.
Programming is now complete.
NOTE: Only one remote can be programmed for each receiver.
WARRANTY
Please refer to the warranty sheet enclosed with your winch for
details.
REPLACEMENT PART NUMBERS
Ordering information: Parts may be obtained through your local
dealer or distributor.
Part Number
Description
PN 90290
Receiver Module/Wiring Harness
PN 74524
Holster
PN 74520
Replacement transmitter (remote)
The above list represents the most commonly requested
replacement parts. A full listing of replacement and service parts
are available.
W A R N I N G
TO AVOID SERIOUS INJURY OR DEATH:
• Never
attempt to service components
inside transmitter or receiver.
• Always
consult an authorized WARN
service center for service or warranty.
Programming LED
Programming button
