PAGE 9
99387 Rev. A0
Winch Installation to a fixed location- continued
To secure the winch, always use:
▫
A flat, secure mounting location at least 3/16 in. (4.8 mm) thick steel.
▫
3/8 in. lockwasher x 4.
▫
3/8-16 x 1in. long, hex head capscrew, Grade 5 or better x 4.
▫
Torque mounting bolts to 30-35 ft-lbs (41-47 Nm
).
Bolt length may need to be longer than specified above depending upon the thickness of the material the
winch is mounted to.
Wiring Instructions
WARNING
Shock & Fire Hazard
Failure to observe these instructions could lead to severe injury or death
.
Never route electrical cables across sharp edges
Never route electrical cables through or near moving parts.
Always read and follow all wiring instructions included in operators guide.
Always insulate and protect all exposed wiring and electrical terminals
Install battery cables with red lead connected to the positive terminal of battery, and black lead to
the negative terminal of battery.
Verify that all wiring connections are clean and tight.
Before using the winch, verify the following:
Wiring to all components is correct.
There are no exposed wiring or terminals, cover any existing exposures with insulator plate,
terminal boots, heat shrink tubing or electrician’s tape.
