User Guide Vehicle-Dock WAP 2.4
1
User Guide
Vehicle-Dock WAP Rev. 2.4
(Type: 4600-0225)
Information on the different Vehicle-Dock WAP variants
The correct function of the Vehicle-Dock WAP is only warranted if you take the right
WORKABOUT PRO model as shown in this overview:
WORKABOUT PRO model
7525C
7527C-G2
7527S-G2/G3
Vehicle-Dock WAP variant
C G1
C G2
S G2/G3
Certificate
Vehicle-Dock WAP (here, also called as “Vehicle Cradle”) has type-approval of a type of
component with regard to Directive 72/245/EEC, as last amended by Directive 2006/28/EC.
Type-approval No. :
e1*72/245*2006/28*5035*00
Safety information on the installation in a vehicle
Caution!
Do not mount the vehicle cradle in the area of activity of the
airbags.
Caution!
When installing the cradle, ensure that it does not represent a risk
in the event of an accident.
Caution!
If you have connected the v ehicle cradle to the power supply using
a cigarette lighter, remove the connector before you leave the vehicle
standing for a long period of time.
As the vehicle cradle requires a constant power supply, it could run down
the vehicle's battery.
Note
Only the manufacturer or authorized partners are allowed to rebuild the
vehicle cradle for other WORKABOUT PRO models.
Liability
The documentation is subject to change without notice. HWU Elektronik GmbH is not liable for
the accuracy of the information contained in this manual or for damages resulting from the use
of this manual.
Trademarks
All brands and trademarks mentioned in this document are possibly registered by third parties
and are subject to the current legislation and to the rights of their respective owners without
reservation. All mentioned names of products, societies, or brands may be registered
trademarks of their respective owners. Every right that is not explicitly accorded is reserved.
UserGuide_4600-0225_Rev2.4_G3.odt
Release 1
User Guide Vehicle-Dock WAP 2.4
2
The absence of an explicit labelling of registered trademarks does not allow the conclusion that
this brand was not subject to the rights of third party.
l
RAM Mount is a trademark of National Products Inc.
l
WORKABOUT PRO is a trademark of Psion Teklogix Inc.
Mounting in vehicle
To mount the Vehicle Cradle you can take a RAM -
Mount. To connect between RAM-Mount and the
Vehicle Cradle take the delivered self-locking nuts.
RAM Mount
Wiring Vehicle Power to Vehicle Cradle
Voltage range: 12 - 24 Volt
Variant 1: Cable with open end
Wire assignment:
Blue: minus
Brown: plus
Variant 2: A power cable (AMP - circular plastic connector - 2-pin) extends from your Vehicle
Cradle power (Psion Teklogix P/N 13985-002)
Pin assignment:
Pin 1: plus
Pin 2: minus
Please note that the power supply cable has to be fused with 2 Ampere!
Special functions
Power supply through the RS232-port
5 V (max. 100 mA) are permanently available on the RS232-port PIN-9 at the top end of
the Vehicle Cradle when it is connected to the vehicle power supply (12V to 24V).
UserGuide_4600-0225_Rev2.4_G3.odt
Release 1
