-
１６
-
1
st
line.
DC TIG/AC square wave TIG
2
nd
line.
2-step (Non-Autolock)/4-step (Autolock)
When the lamp in 5
th
or 7
th
line is selected, the digital displayer will
show values of respective parameter setting. They can be adjusted by
pressing and tuning the regulation knob clockwise to increment, counter
clockwise to decrement. Press the knob and tune simultaneously for
quick setting.
“2-step” refers to start welding while push torch trigger, stop welding
while releasing it.
“4-step” refers to output starting-arc current while firstly pushing torch
trigger, then current slopes up to where can welding normally while
releasing it. When welding finished, current slopes down to where fills
crater and maintains while pushing it again, then stop outputting current
while releasing it.
3th line
Constant current TIG/Pulse TIG /SMAW
4
th
line
Summary of Contents for INTIG-315 AC/DC
