-
８
-
Table1: The size of fuse and breaker in the table are for reference only
4. Installation
The input power of this series welding machines is three phase
AC 380v/50Hz. Operator must use the properly disconnected
switchboard or switch box(not provided by our company) which
is equipped circuit breaker, and should ground the welder safely
and firmly.
(1)
Connect ground lead.
(2)
Connect terminal socket (+) to workpiece on DC TIG, to
stick holder cable on SMAW.
(3)
Connect terminal socket (
∽
) to workpiece on AC TIG (IN
TIG 315 AC/DC) still use terminal socket (+) to connect
workpiece).
(4)
Connect TIG torch to terminal socket (-) on AC or DC TIG,
connect socket (-) to workpiece on SMAW.
(5)
Connect welder’s gas inlet to gas regulator by gas hose.
(6)
Connect TIG torch’s gas inlet to welder’s gas outlet.
Product
type
315 500 630
Power supply
3 phase AC380V
Min. capacity
Power
network
14KVA 27KVA 45KVA
Input volt
protection
Fuse
20A 40A 60A
Circuit
breaker
40A 60A 100A
Cable size
(cross-section)
Input volt
4mm
2
6mm
2
10mm
2
Output volt
35mm
2
50mm
2
70mm
2
Ground lead
4mm
2
6mm
2
10mm
2
Summary of Contents for INTIG-315 AC/DC
