13
3.4.10 Motor cover installation
Install the motor cover by inserting the door pins
into the hinge sockets on the cabinet as shown in
Fig. 20.
Fig. 20
3.4.11 Electrical installation
Wiring should only be done by professional
electricians.
Always make sure the machine is properly
grounded. All exposed conductive parts should
be connected to the protective ground circuit.
An over-voltage protection device should be
provided by end user.
The circuit breaker shall be installed to supply
electric power to this machine, in order to
protect people against electrical shock due to
incidental contact.
Check that the voltage and frequency required by
the machine, which is shown on the machine’s
name plate, correspond to the electric power
supply voltage and frequency.
Ensure IP54 protection class for the incoming
cable when the finished installation is in place.
Checking:
After finishing wiring in place, at minimum, check
the following items:
1.
Check the direction of motor and change the
wiring if necessary.
2.
Check the components for defects, such as
damaged cable or plug.
3.
Check the function of the “OFF” button.
