15
4. Adjustment
Before operation, Please make adjustments as
followings:
4.1 Adjusting the Rip Fence
Before using the rip fence, the parallelism and
perpendicularity must be aligned correctly. Please
refer to chapter
5.4.4 Install the rail & fence
.
4.2 Aligning the Table T-slot Parallel with
the Blade
1.
The table T-slot must be aligned parallel with the
blade. Using a combination square measure the
distance from the back edge of the blade to the
table T-slot. Pivot blade forward 180º and re-
measure the distance using the exact same point
on the blade. The difference between both
measurements must be less than 0.2mm. Refer to
Fig. 21.
Fig. 21
2.
If an adjustment is necessary, loosen the
screws identified in
Fig. 22
which mount the table
to the cabinet. Make the needed adjustment until
both measurements are equal or less than 0.2 mm.
and re-tighten the screws.
Fig. 22
4.3 Adjusting the 45° and 90° Positive
Stops
The tilt mechanism has adjustable stops for 45° and
90°. The machine comes factory-set but should any
positioning deviation of the blade occur, you can re-
adjust the stops. Refer to
Fig. 23.
Fig. 23
To adjust the 90° Positive Stop: open the motor cover
on the right side of the machine. Then loosen the
locking nut (A) and adjust the limit screw (B) until it
contacts with the positive stop. Tighten the locking
nut(A).
To adjust the 45° Positive Stop: loosen the screws of
the repair panel on the left side of the machine and
take off the repair panel. Then loosen the locking
nut(C) and adjust the limit screw (D) until it contacts
with the positive stop. Tighten the locking nut(C).
