UPS-Division
Operating Manual Wärtsilä JOVYLINE 625/1200/2200 BAX 3522 E page 5
2. Security
To avoid an electric shock you have to disconnect the UPS from the mains
before connection of the computer to the UPS.
In case of works on the UPS you have to secure that the UPS is in OFF-modus
and disconnected from mains. The I/O switch at the back of the UPS has to be in
OFF-position. After that you can open the UPS and disconnect the batteries.
Don’t put the batteries into fire – they could explode.
Don’t open the battery-blocks. The acid inside these blocks injures skin and
eyes.
Even a multicellular battery can lead to an electrical shock. Therefore don’t touch
both poles at the same time. Before works at the battery you have to secure, that
there are no metallic things such as rings, bracelets etc. at your arms and hands
which could lead to a short circuit at the poles of the battery. A short circuit on
the battery can produce a very high short circuit current which leads usually to
bad burns and the UPS will ignite.
Don’t connect the mains input with the mains output of the UPS. The UPS could
be damaged.
Attention!
Improper handling of the UPS implies a higher risk of electrical shock. Even after
disconnection of the UPS from the mains there may be voltage at the output!
Attention!
Only authorised persons are allowed to open the UPS. Don’t remove the covering of
the UPS. Avoid the danger of an electrical shock.
There is no component part within the UPS which has to be replaced by the user.
Warning!
To avoid fire please use only the integrated original fuses!
Warning!
To reduce the risk of fire or electrical shock the UPS shouldn’t placed in areas with
to high temperatures or humidity. It’s recommendable to install the UPS insides of
air-conditioned rooms.
