Wärtsilä JOVYSTAR COMPACT M
BAX 5480
- 51 -
Supply reset
Reset the output supply only when the causes which led to the emergency shutdown have
been eliminated and you are sure that there is no hazard to persons and things.
11.4.3 Normal/Bypass Selector
The Normal/Bypass selector is installed externally, on the rear of UPS. It is generally used during the
manual bypass procedure, when it is necessary to isolate the UPS for maintenance or repair.
Follow the procedures contained in the manual
The Normal/Bypass selector shall only be operated in accordance with the procedures
specified in the installation and start-up section. The manufacturer cannot accept
responsibility for damages arising from incorrect operation.
11.4.4 LCD control panel
The control panel of the UPS is used in order to:
Check the operating parameters of the device
Check the alarms present
Access the event log
Display the information on the device
Modify the operating parameters
The menu which allows to change the parameters is password-protected in order to prevent access to
unauthorized personnel.
