Wärtsilä JOVYTEC PMS 6000 BAX 2935_en
- 24 -
6. ESCAPE
button
By pushing the
ESCAPE
button you can leave the menue.
The operating mode and actual condition of the UPS is displayed by means of 5 LED´s on the
operating panel.
The conditions are as follows:
7. ON
: This LED glows green if the UPS is switched on
8. ON-LINE
: This LED glows green both in UPS mode and in bypass mode and also signals that there is
an voltage at the output.
9. ON-BAT
: This LED glows yellow for battery operation (power failure)
10. BYPASS
: This LED glows yellow if the UPS unit is running inbypass mode
11. FAULT
: This LED glows red if there is an internal error in the UPS, and an acoustic signal is emitted.
Press any key in the function panel and the alarm will be switched off. The cause of the alarm
is shown in the display.
7.2
Parameters of the UPS unit
Indicator
Function of the indicator
O/P VOLT = 230.0V
Output voltage of the UPS
O/P FREQ = 50,0Hz
Output frequency of the UPS
I/P VOLT = 230,2V
Input voltage of the
UPS
I/P FREQ = 50,2Hz
Input frequency of the UPS
BAT VOLT = 72V
Battery voltage of the battery pack
O/P LOAD% = 80%
Utilisation of the UPS as a percentage
O/P W = 1400W
Output in Watts
O/P VA = 2000VA
Output in VA
O/P CURR = 13A
Output current in A
BACKUP TIME = 3Min.
Autonomy time for the current loading
BAT CHARG = 80%
Battery charge level in percent
TEMPERATURE = 28°C
Temperature of the UPS
BAT PACK NUM = 2
Number of battery packs used
RATING = 2000VA
Nominal value of the UPS in VA
CPU VERSION 3.12
CPU software
Summary of Contents for JOVYTEC POWERMASTER PMS 6000
Page 2: ...Operating Manual W rtsil JOVYTEC PMS 6000 BAX 2935 E...
Page 17: ...W rtsil JOVYTEC PMS 6000 BAX 2935_en 16 5 6 2 Powermaster S 6000 mounted in 19 Cabinet...
Page 18: ...W rtsil JOVYTEC PMS 6000 BAX 2935_en 17 5 6 3 Powermaster S 6000 as Table Device...
