8
Chapter 4
8
SETUP AND CONFIGURATION/FACTORY DEFAULT/AUTOSENSE STAND MODE
Use the Factory Default barcode to reset the scanner to the Default settings.
Factory Default
In order to configure the Wasp WWS250i Scanner, you must familiarize yourself with the setup procedures on the following pages.
The default settings of the scanners are identified on each page and clearly marked using an asterisk (*). The default settings have
been preprogrammed for the most common barcode configurations. Use the setup & configuration barcodes only to customize the
WWS250i Scanner settings. If you need to configure the Scanner, the default settings will be overwritten. All the programmed settings
are stored permanently in non-volatile memory.
In order to configure the Wasp WWS250i Scanner, two basic steps need to be followed:
(1) Locate the group that contains the options to be changed.
(2) Scan the barcode representing the option to be changed. The scanner will sound two beeps.
To change Minimum/Maximum Length:
(1) Scan the Minimum or Maximum Length barcode associated with the symbology.
(2) Scan a 2 digit value from the numbers on page 10.
(3) Scan the Minimum or Maximum Length barcode again.
Example: To have a minimum length barcode of 1, you must scan a 0 then 1, then scan the minimum barcode again. To have a
maximum length barcode of 10, you must scan a 1 then 0, then scan the maximum barcode again.
Setup & Configuration
Factory Default
