INTRODUCTION
© WASP S.r.l.
3
22
Description of the printer
3
2.7. Noisiness
The noise emitted by the standalone printer is lower inferior than 70 dB(A).
The presence of more machines in the same area can increase the global noise.
ATTENTION:
It is the responsibility of the customer to carry out an assessment of the noise risk of his activity
as prescribed by the legislation in force in the place where the printer is installed, and to equip
the operators with adequate Personal Protective Equipment (such as headphones for hearing
protection).
2.8. Intended use of the printer
The printer was designed and built to create thermoplastic objects by depositing a filament of molten material. It
is possible to use materials such as
TPU, TPE, PP
.
Any use of the printer with materials other than those officially supplied will void the manufacturer’s warranty and
liability.
2.9. Improper use of the printer
The following printer uses are prohibited:
• Using the printer to perform operations other than those for which it was designed and constructed described
in paragraph 2.6;
• Failure to comply with safety regulations;
• Operation of the printer with procedures other than those described in this manual;
• Use components not provided for in the design phase;
• Failure to comply with established maintenance schedules;
• Perform work on the printer that involves the modification of components or parameters that affect the work
cycle;
• Alter the extruder calibration;
• Use of the printer outside the permitted working temperatures;
• The use without authorization of non-original spare parts or components not approved by the Manufacturer;
• The execution of any modification or structural intervention without the Manufacturer’s authorization;
NOTE:
• Each of the improper uses or negligence previously listed causes:
• the immediate cancellation of the guarantee stipulated with the Manufacturer at the time of the
purchase of the printer;
• the cancellation of the Manufacturer’s Responsibility for damages caused to people, things or
animals.
ATTENTION
Improper use can damage the printer which consequently can cause dangerous situations for the
personnel responsible for its operation and maintenance.
Summary of Contents for 4070 FX
