INTRODUCTION
© WASP S.r.l.
70
Use of the printer
8.8. Manual control
Manual control is a tool accessible when the machine is turned on and operational.
With this tool it’s possible to control manually all the motors in the machine: X(left column),Y(right column),Z(back
column) and E(filament threader).
MOVING X, Y or Z axis
The procedure for moving X,Y or Z axis is:
1. Use the command PRINT>AUTOHOME
2. Access ADVANCED>TOOL>MANUAL CONTROL
3. Select from the bar on the top the desired scale in mm
4. Chose +X, -X, +Y, -Y, +Z or -Z to command the machine the movement in the specified direction
Remember that whenever the machine touches an endstop the operation will be aborted.
EXTRUDING or RETRACTING (E axis)
The procedure for moving X,Y or Z axis is:
1. Assign the extruder to move a target temperature depending on the material loaded
2. Use the command PRINT>AUTOHOME
3. Access ADVANCED>TOOL>MANUAL CONTROL
4. Select from the bar on the top the desired scale in mm
5. Chose EE) to extrude material and RETRACT(-E) to retract material
The speed of movement for the Manual Control command is fixed.
For materials with low Melting Flow Index or highly compressible the Manual Control extrusion could be too
fast. In that case choose a lower scale value (for example 1mm instead of 10 mm)
Summary of Contents for 4070 ZX
