4.2 Code Mark ( Code ID) Parameters
You may use the example listed below to define the
code mark for your own applications.
Please note that each code mark you define
has to follow the steps as example shown
below . You may also refer to Chapter 5
for details.
For example: to define " Z " as code mark for code 39. , the
steps will be as under :
a) Scan " Start " label.
b) Scan Code 39 label as below.
c) Refer to Appendix A. ASCII Code Table where shows
" 5" "A" stand for " Z".
d) From Appendix D. Hex-Label to scan " 5" "A" labels.
e) Scan " EXIT" label also from Hex-Label Table.
f) Scan " END" to complete your definition
Code Mark Parameters
Code 39
IND 2/5
CODABAR
EAN-8
Code 128
ITF 2/5
MTX 2/5
EAN-13/UPC-A
UPC-E
Note: 1. Read code type and then CANCEL label.
2. Please follow the rule for cancellation step by
step, i.e.: to read one code type and then
scan CANCEL label.
CANCEL
27
4.3 Pre-amble and Post-amble
Pre-amble & Post-amble
Pre-amble=??
Post-amble=??
Note: 1. You can define maximum 10
characters/digits for each pre-/post-amble.
2. Please refer to examples in Chapter 5.
Cancellation of Pre-amble & Post-amble
Pre-amble
Post-amble
CANCEL
Note: Read pre-amble for post-amble first and then
CANCEL label afterwards.
4.4 Buzzer Parameters
Buzzer Pitch & Duration
Buzzer pitch=?? (0-22)
Buzzer duration=?? (0-127)
Buzzer parameters include buzzer pitch ( buzzer
frequency) and buzzer duration.
28
