19
2
© WASP S.r.l.
2.4. Noisiness
The noise emitted by the machine only is inferior than 70 dB(A).
The presence of more machines and printers in the same area can increase the global noise.
ATTENTION:
It is the responsibility of the customer to carry out an assessment of the noise risk of his activity as
prescribed by the legislation in force in the place where the machine is installed, and to equip the
operators with adequate Personal Protective Equipment (such as headphones for hearing protection).
2.5. Intended use of the continuous feeding
The machine has been designed and built to feed a 3D printer with ceramic mixtures. It is possible to use materials
such as porcelain, earthenware, stoneware, etc.
Any use of the machine with materials other than those supplied will void the warranty and the responsibility of
the Manufacturer.
2.6. Improper use of the feeder
The following machine uses are prohibited:
• Using the machine to perform operations other than those for which it was designed and constructed
described in paragraphs 2.3 “Technical Data” and 2.5 “Intended use of the machine”;
• Failure to comply with safety regulations;
• Operation of the machine with procedures other than those described in this manual;
• Use components not provided for in the design phase;
• Failure to comply with established maintenance schedules;
• Perform work on the machine that involves the modification of components or parameters that affect the
work cycle;
• Use of the machine outside the permitted working temperatures;
• The use without authorization of non-original spare parts or components not approved by the Manufacturer;
• The execution of any modification or structural intervention without the Manufacturer’s authorization;
NOTE:
Each of the improper uses or negligence previously listed causes:
• the immediate cancellation of the guarantee stipulated with the Manufacturer at the time of the
purchase of the machine;
• the cancellation of the Manufacturer’s Responsibility for damages caused to people, things or
animals.
ATTENTION
Improper use can damage the machine which consequently can cause dangerous situations for the
personnel responsible for its operation and maintenance.
