© CSP S.r.l.
70
Use of the printer
8
8.12. Resurrection system
The Resurrection system is a command for the automatic recovery of the print jobs interrupted by a sudden
switch-off during processing.
The system is designed in particular for:
Blackouts and sudden power failures during printing
Accidental removal of the power cord during printing
In addition, it should be considered that in the time span between turning off the machine and launching the
“Resurrection” command, the printed piece is cooled and this in some cases may cause problems in recovering
the print.
8.13. Removal of the print
To perform a removal of the piece from the printing bed, it is required:
•
For this operation is not important if the printer is stopped, turned on or off
•
For safety reason it’s better that the extruder has cooled down
What can help in removing the piece is:
•
Make use of appropriate tools such as the spatula
•
Wait until the table temperature has dropped
Summary of Contents for DELTA 2040
