Standard 2 of 5
Enter/Exit Programming Mode
Product Reference Guide
131
Standard 2 of 5 Set Length 2
This feature specifies one of the barcode lengths for
Standard 2 of 5 Length Control
the maximum label length if in
Variable Length
Mode, or the second fixed length if in
Mode. Length includes the barcode’s check and data characters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
provides examples for setting Length 2. See
for detailed instructions on
setting this feature.
Table 10. Standard 2 of 5 Length 2 Setting Examples
STEP
ACTION
EXAMPLES
1
Desired Setting (pad with
leading zeroes)
00 (Ignore This
Length)
07 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT STANDARD 2 OF 5 LENGTH 2 SETTING
4
Scan Two Characters From
‘0’ and ‘0’
‘0’ and ‘7’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
$CS2L2
Select Standard 2 of 5 Length 2 Setting
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
Summary of Contents for WDI4600
