If the scanner exhibits strange behavior or will not send data after successfully completing
the linking process, scan the following barcode to restore the scanner to factory default
settings (from page 9):
=======================================================
===
WWS650 & WWS750: link scanner to base (comprehensive steps if there is trouble pairing):
1a. WWS650: The base station requires connecting the USB data cable from the base to the
PC. There is no separate power supply needed.
1b. WWS750: The base station requires connecting the AC power cable (from the wall), and
the USB data cable from the base to the PC.
2. Scan "Reset Default Settings" configuration barcode . There should be 2 short beeps, 4
short beeps, then 3 ascending beeps.
3. Press and hold the button on the base (next to the LED lights) for more than 5 seconds,
then release. The "RADIO" LED will blink rapidly, then change to a slower blink. Release the
button after the slower blinks start.
