Installing a spare grinding disc on an existing disc mounted in the unit,
regardless of its origin or model type, is strictly prohibited by Wassermann.
Warning!
The use of diamond grinding discs to grind embedded material and metals will
result in excessive wear on the blade. We assume no responsibility if this occurs.
Responsibility for the product becomes void if alterations are made to it by third
parties or if non-approved parts are installed. Only original WASSERMANN parts
should be used. If any damage results from the installation of a non-approved
disc, responsiblity lies with the person installing that spare disc.
12.7
Foil Grinding Discs
These discs can be turned around and remounted after one side has been used up, thus
allowing you to continue working. This increases disc life considerably.
•
Loosen the star handles to take off the front cover.
•
Loosen the central screw on the axle counter-clockwise and hold the grinding disc.
•
If necessary loosen the thrust piece by sticking a screwdriver between the thrust
piece and the grinding disc and take it off together with the PVC washer.
•
Turn around the foil grinding disc.
•
Put on the thrust piece and the PVC washer and screw on the central screw.
•
Clean the contact surfaces of the housing parts and seal them with the grease
supplied by applying a line of grease on one part of the housing. Do not spread it.
•
Put back the front plate and fasten the star handles tightly.
•
Remove any spare grease.
16
