Hardware Description and Assembly
4
Hardware Description and Assembly
Place the TO-Clean on a bench top or on the optional system cart.
Vacuum Pump
The TO-Clean comes with an Edwards BOC RV-8 vacuum pump. Unpack the
pump and place it on the floor next to the canister cleaner. Attach the vacuum
hose to the top of the pump, using the metal clamp, as shown in Figure 1.
The oil mist filter and oil ballast have been pre-assembled at the factory and are
connected by a short piece of tubing. Unscrew the gray oil ballast cap and screw
the oil ballast into the threaded hole until tight. Remove the clear cap from the
black mist filter fitting on the pump. Place the oil mist filter on top of the black
fitting and secure using the metal clamp.
Unscrew the two gray oil caps on the pump and pour the oil that came with the
vacuum in either of the inlets. There is an oil level window on the back of the
vacuum. The oil reservoir should be 1/3 – 1/2 full. You should not need the
entire bottle for the first fill. Screw the oil caps back on before turning the pump
on.
For further information on the Edwards pump see the manual and CD included in
the shipment.
