![background image](http://html2.mh-extra.com/html/wassp/wmb-3250/wmb-3250_installation-manual_3494803034.webp)
Doc. P/N:
WSP-009-005
Version: V1.5
Issue Date:
October 2013
www.wassp.com
Page 34 of 73
Installation Manual
3
Add a GPS device and select this for Position update (also Speed or anything else this
device is providing you). Set any offsets and connection settings as per normal. Test the GPS
configuration using the
Test
button.
Figure 25. HYPACK
®
Hardware System Setup
4
Once the GPS device is created, select the base of the HYPACK
®
Configuration Tree. This
will then show an option to Synchronize the Computer Clock. Select the GPS device from the
list. If this is not done the systems will run out of sync and pings will not appear in the correct
position.
5
Save all of these changes and close these windows.
6
Open up the HYSWEEP Hardware configuration.
Figure 26. HYSWEEP Hardware Selection
7
Select WASSP Multibeam and Add the device to the project.
8
Now select the WASSP Multibeam device on the right hand list and then choose the Connect
Tab.