Doc. P/N:
WSP-009-004
Version:
V1.3
Issue Date: August 2013
Page 9 of 62
Operator Manual
3. Operating Procedures
1
Start up WASSP Application:
a. The WASSP PC Application software self loads
on system start up.
b. When the WASSP System program starts
up, a Navigation Warning screen similar to
the one shown in “Figure 3. WASSP System
Multibeam Sonar System Navigation Warning”
is displayed.
c. Click on OK to accept the navigation warning
message.
If no dongle is found, a Dongle Error box
appears on the screen.
Ensure a dongle has been plugged into the
computer’s USB port and click Retry.
d. Verify that the BTxR and appropriate sensors
are switched on.
e. Check the connection status for Processing
Module, Transfer Task, BTxR and Navigator.
Connection Status icons will appear green
when connected. See “4.1 Connect Status
Icons” on page 12.
Figure 3. WASSP System Multibeam Sonar
System Navigation Warning
You can click
Cancel
DQGUXQDGHPR¿OHIURPWKH6\VWHP
&RQ¿JXUDWLRQ8WLOLW\
2
Choose a display mode:
See “4.7 System Views” on page 16.
Note: It is usually easier to select the
display modes after you have started
transmitting, as you can see the actual
modes displayed.