4
WatchGuard AP102
Hardware Specifications
Hardware Description
Device Connections and Buttons
Ethernet Network Interface
Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps.
Power Input
If you use the optional 12V AC adapter, connect the AC adapter to the device and to a power source.
Use only the WatchGuard AC power adapter for this AP device model.
If you use a PoE adapter other than the optional PoE adapter from WatchGuard, make sure that it
complies with the IEEE 802.3af/at PoE specifications.
Reset Button
Resets the WatchGuard AP device to factory-default settings. You must use a paper clip or other small
object to press the reset button through the small hole on the top of the device. The reset button
functions differently based on the version of AP device firmware the device uses.
For an AP device that uses AP device firmware 1.2.9.2 or higher
To reset the device to factory-default settings, with the AP device powered on, press and hold
the reset button for at least five seconds. After you reset the device, the Power/Status light
flashes Amber and Green to indicate that the AP device is not paired to a Firebox or XTM device.
To reboot the device, but not reset it to factory-default settings, press the reset button briefly
(less than 5 seconds).
For an AP device that uses AP device firmware 1.2.9.1 or lower
To reset the device to factory-default settings, with the AP device powered on, press and hold
the reset button for at least 12 seconds.
You can see the current AP device firmware version in the Gateway Wireless Controller on the Firebox
or XTM device that manages the AP device.