Watchguard Surveillance Quick Start Guide - Version: WGDVR-Q119
2
1. Pre-Installation
Before connecting your DVR (digital video recorder) or cameras, please ensure the following safe installation guidelines
are adhered to.
• Do not place cords from the DVR where they can be pinched or stepped on.
• Do not place heavy objects on cords, or cover cords with rugs or carpet.
• Do not expose the DVR to excessive heat or moisture.
• Leave at least 50mm of space between the DVR and other objects to allow ample air circulation.
• Never immerse any component in water and do not spray cleaners or solvents on the cameras.
• Shut down and unplug the recorder before cleaning. When cleaning, use a damp, lint-free cloth only.
•
Service of your DVR or surveillance cameras should only be handled by qualified technicians.
1.1 Pre-Installation Safety Information
1. Connect the cameras to the DVR:
Using coaxial cables, connect the BNC plugs to the DVR.
2. Connect camera power:
Using a 12VDC power supply.
3. Connect a display:
Using an HDMI or VGA cable, connect a monitor or television (not included).
4. Connect the mouse:
Connect the USB mouse to the rear USB port, saving the front port for easy USB backup.
5. Connect to your local network:
Using the included Ethernet patch cable, connect to your switch or router.
6. Connect DVR power:
Using the supplied 12VDC 2A digital video recorder power supply.
Upon activating power, LED lights at the front of the DVR should turn on and the DVR will sound on startup. The
DVR will then run your surveillance user interface. Cameras and LAN / Internet will be detected automatically. This
completes a successful first boot of your surveillance system and you may begin configuring surveillance cameras.
1.2 Connecting your DVR and Cameras
The following section will detail connecting the DVR (digital video recorder) and surveillance cameras. It is recommended
that cameras and connections are tested before mounting. If there is no image, an error message or dark screen when
first connecting cameras, see the
Troubleshooting
in Section 6 in this guide.
Refer to
1.3 DVR Rear Panel & Setup Diagram
for full DVR & system diagrams.
