4
WatchGuard Firebox M4600
Hardware Specifications
Hardware Description
Front View
Firebox M4600 front view:
Left front panel detail:
Buttons and Indicators
Power (
)
The power indicator on the left front of the Firebox is green when the Firebox is powered on.
Arm/Disarm (
)
When the Firebox is armed and ready to pass traffic, this indicator is green. When the Firebox is
powered on, but not ready to pass traffic, this indicator is red.
Storage (
)
When there is activity on the CFAST card or hard disk this indicator is yellow.
Power Button (
)
The Power button, on the left side of the Firebox, is lit to indicate power status. It is green when the
Firebox is powered on, and red when power is available, but the Firebox is powered off.
When the Power button is red, press this button to power on the device.
When the Power button is green, press and hold the power button for five seconds to power off the
device. The Firebox does not power off if you briefly press the power button.
Reset Button
The Reset button, located to the left of the USB interfaces, resets the device to factory-default
settings. To reset the device, use the procedure in “Restore Factory-Default Settings” on page 10.
