Chapter 3: SOHO 6 Basics
26
WatchGuard Firebox SOHO 6.1
Firewall Settings
All incoming services are blocked.
An outgoing service allowing all outbound traffic.
None of the Firewall Options are enabled.
The DMZ pass-through is disabled.
System Security
System Security is disabled and no System Administrator
name or passphrase is set–the configuration pages are
available to all on the trusted network.
SOHO 6 Remote Management is disabled.
VPN Manager Access is disabled.
No remote logging is configured.
WebBlocker
WebBlocker is disabled and no settings are configured.
Upgrade Options
No upgrade options are enabled until the license keys are
redeemed.
Reset a SOHO 6 to factory default
Firmware corruptions or other unforeseen events (such as a lost
System Security passphrase) require you to reset the SOHO 6 to its
factory default settings.
To do this, first disconnect the power supply. Then find the reset
button located at the rear of the SOHO 6. Press and hold the reset
button. At the same time, reconnect the power supply. Continue
pressing the reset button while the SOHO 6 reboots–
approximately 15 seconds. The PWR indicator light should blink
in a steady pattern once the reboot is complete. When this occurs,
reboot the SOHO 6 again by disconnecting the power supply.
Summary of Contents for Firebox SOHO 6.1
