CHAPTER 3: Configuration Mode Commands
86
WatchGuard Vclass 5.1
Arguments
<a.b.c.d>
This argument records the IP address assigned to
this interface.
</prefix|mask>
This argument records the number of bits in the
subnet mask, or the subnet mask.
dhcp_server
Enter this argument to activate DHCP server
service on this appliance.
-clients NUMBER
This argument indicates the number of clients
permitted DHCP access.
-lease_time NUMBER
This argument indicates the lease time for all client
connections, and any limitations, recorded as
minutes.
[no] dhcp_server
Enter this argument to disable any previously
active DHCP service.
Example
WG(config-if)#private 192.168.1.1 255.255.255.0
dhcp_server \
-clients 3 -lease_time 60<ENTER>
interface 1 command (configure interface level)
WG#config<ENTER>
WG(config)#interface<ENTER>
WG(config-if)# interface 1 [<a.b.c.d> </prefix|mask> |
[-mtu num] |
[-100_full_duplex | -100_half_duplex|
-10_full_duplex|-10_half_duplex | -auto]] |
[dhcp [host_id]] |
[pppoe -user "name" -password "password"
[<-dial_on_demand|-always_on> <num>]]
[-unnumbered_pppoe <a.b.c.d>|disable]]
[backup [ip <a.b.c.d> mask <a.b.c.d> gateway <a.b.c.d> ]|
[dhcp [host_id] ] |
[pppoe -user "name" -password "password"]
