6
WatchGuard XTM 3 Series
Hardware Specifications
Environmental Requirements
To safely install your XTM 3 Series device, we recommend that you:
Install it indoors.
Put it in a secure area, such as a locked room, to block the device from people who do not have
permission to use it
Connect it to a conditioned power supply to prevent damage from sudden power changes
Other environmental requirements:
Safety Notices
All WatchGuard products are designed and tested to meet strict safety requirements. These requirements
include product safety approvals and other global compliance standards. Read these instructions carefully
before you operate the product, and refer to them as needed for continued safe operation of your product.
Product Safety Certification
The WatchGuard product is safety certified for these standards:
o
CAN/CSA C22.2 No.60950-1-07
o
IEC 60950-1, Second Edition
o
UL 60950-1, Second Edition
Safety Warning
o
Do not place objects on the power cord.
o
Do not obstruct the ventilation openings. These openings prevent overheating of the XTM device.
o
Never push objects of any kind into slots or openings on this equipment. If you make contact with a
voltage point or short out a part, it can result in fire or electrical shock.
o
If the equipment is supplied with a three-conductor AC power cable, the power cable must be
plugged in to an approved three-contact electrical outlet with the grounding wire connected to an
electrical ground (safety ground) at the power outlet.
o
When you remove or install an appliance, follow the general installation safety instructions provided
in this Hardware Guide to avoid injury or damage to the device.
The lithium battery used in the security appliance may not be replaced by the user. Return the appliance to a
WatchGuard authorized service center for replacement with the same or equivalent type recommended by
the manufacturer. If, for any reason, the battery or security appliance must be disposed of, do so following the
battery manufacturer’s instructions.
Operating temperature
0 – 40°C (32 – 104°F)
Operating relative humidity
10% - 85% Non-condensing
Non-operating temperature
–40 – 70°C (–40 – 158°F)
Non-operating relative humidity
10% – 95% Non-condensing
