3
PRE-INSTALLATION INSTRUCTIONS
THE DEALER SHOULD...
•Read this page and guide the installer
regarding hardness, day override, time of
regeneration, service alarm, and buzzer alarm
settings prior to installation.
THE INSTALLER SHOULD...
•
Program installer settings including hardness,
day override, time of regeneration, service
alarms, and buzzer alarm.
•
Read Operating Displays and Maintenance
section.
•
Set the time of day
•
Read Power Loss and Error Display section.
•
Ensure that system and installation are in
compliance with all state and local laws and
regulations
THE HOMEOWNER SHOULD...
•
Read Programming Procedures section.
•
Read Operating Displays and Maintenance
section.
The manufacturer has preset the water treatment unit’s sequence of cycles, cycle times, salt dose, exchange capacity and salt dose refill time.
GENERAL OPERATING DISPLAYS & NAVIGATION
During normal operation, the default user displays are “time of day” and “gallons per minute”. Flow rate, vacation mode, capacity remaining, and
days to a regeneration are optional displays. For more explanation, consult the “operating displays and maintenance section”. Pressing the
NEXT
button on a general operating screen will cycle through the available operating displays.
In any screen other than a general operating display, the
NEXT
button will proceed to the next step, the
REGEN
button will return to a previous step,
and the
CLOCK
button will return to the general operating displays. Any changes made prior to the exit will be incorporated. If no buttons are pressed
within five minutes, the display will return to the general operating displays.
DOUBLE REGENERATION
Two generations within 24 hours are possible with a return to the preset program. To initiate a double regeneration:
1. Press the
REGEN
button once. “REGEN TODAY” will flash on the display.
2. Press and hold the
REGEN
button for three seconds until a regeneration begins.
Once the valve has completed the immediate regeneration, the valve will regenerate once more during the preset time.
