4
1.
Place the T-Handle into the Handle Base / Foot Bracket and align the Spring
Button with the hole in the base so the button snaps into the hole.
2.
Pull the lever on the Cam Lock Clamp out away from the handle tube to
loosen the clamp. Pull the handle up to adjust the handle height for
comfortable operation.
3.
Push the lever on the Cam Lock Clamp down to tighten the clamp and
secure the handle at the desired height. If the clamp is too loose, the clamp
can be tension can be increased. Pull the lever out and then tighten the
Tension Nut on the Cam Lock Clamp to increase the tension level as
needed and then push the lever back down to secure the handle.
ASSEMBLING THE WATER CLAW
SPRING BUTTON
NM5507
HANDLE BASE / FOOT BRACKET – NM5537A
CAM LOCK CLAMP
TENSION NUT
LEVER
