7
Your Water Claw requires very little maintenance. To keep your Water Claw
looking and working its best for the longest period of use:
•
Rinse the Water Claw after use, wipe down and let dry.
•
Examine the vacuum ports on the base and remove debris as needed.
If an excessive amount of debris has been lodged in the ports or is caught in the
base assembly, the bottom can be removed from the top of the base. Remove the
four bolts holding the handle support/Vacuum relief bracket onto the base. Then
use a Phillips head screwdriver to remove the screws connecting the top plate and
the base plate and pull the bottom away from the top. Clean out the debris and
examine the gasket. Replace the gasket if damaged. Place the top plate back onto
the bottom and re-install the bolts and screws.
The handle of the Water Claw can be removed for storage by pressing in the
lower snap button and lifting the handle up away from the handle support on the
base. The base of the Water Claw can be placed into the Carry Bag and the handle
placed strapped to the Carry Bag for transport and storage.
MAINTENANCE
