User guide
886E - WIFI Version
11
Special situations and reminder
Sensors
If your sensor has been in contact with water, you should change its batteries. The system takes its battery readings at
12-hour intervals. If your sensor has water inside its casing, we recommend that you replace the sensor with a new one.
Reminder
: Water-Protec recommends that you change your batteries every 12 months so that you do not experience low battery
levels that will impair system operation.
Sensors equipped with a wire sensor
Sensors with detection cable are available for hard-to-reach places (under the dishwasher, fridge, etc.). They can also be useful to protect
a main water pipe, for example. Standard sizes are 3, 6 and 8 feet. However, they can be as long as you need.
Valves
Valves of more than 1 inch, they must be equipped with an booster relay.
Artesian well pump
Additional accessories are available to ensure that the system functions optimally. For
example, if you have an artesian well, the system must be equipped with an additional
relay (875). The relay receives a dry contact signal from the receiver to switch off the
power to the well pump. It is designed for 240VAC systems, and pump motors up to
3HP. The control power is 24VAC at 4VA (supplied by the unit’s internal transformer).
If you have a water treatment system with osmosis, such as an artesian well, it is
important to mention this to the plumber who will do the installation since a water
analysis is required. Water with too many minerals could interfere with the proper
functioning of the system.
Small or big,
we can fulfill all
your needs
Whether in the city
or in the countryside
