User guide
886E - WIFI Version
3
Installation
Follow the link to make the installation easier:
youtu.be/kOtS3V0M4w8
Getting ready
First, check the content of the box: make sure all parts are present and
that you have enough sensors for your property configuration.
Using a pencil and inventory sheet, browse your property. Identify
each place to protect and write them on the sheet.
The sensors are powered by two 3V batteries. If the batteries are not
already installed, insert them into the socket on the back of each
sensor. Make sure they are in the “
ON
” position.
Install the 9V battery in the control box. Make sure that the battery is
not discharged by checking that the indicator lights come on.
Plug the control box into an electrical outlet and connect the valve to
the control box.
Before proceeding with the installation, it is important to test the
proper functioning of each component of the system.
Synchronizing and functioning
After the initial power-up, all the LEDs on the the 886E control will flash. This indicates that no control
devices have yet been synchronized (paired) to the unit. This synchronization must be done before the
system components can be deployed.
Synchronizing the remote
The first device to be synchronized with the main unit must be the remote control.
Proceed as follows: Push the
Program
Button on the Main Control Unit to activate Program mode.
When the leftmost three LEDs (1-3) start to flash, the unit is in Program mode and is ready to receive a
synchronizing signal from the remote control. This is sent as follows: push the 2 buttons on the remote
control simultaneously and wait until only the first LED on the Main Control is still flashing and LEDs 2
and 3 are OFF. The remote is now synchronized.
We recommend that the
installation of the valve should
be performed by a
certified plumber
Tools
Here is the list of tools you
will need :
Snap-off
blade knife
Level
Cisors
Mesuring tape
Cutter
Drill
Screwdriver
For plumbing:
Wescott wrench
Teflon tape
Pliers
Program
