User guide
886E - WIFI Version
5
Valve Installation
(continued)
Measure the length of the pipe to be cut and cut the pipe.
Apply Teflon tape to the end caps and securely thread the
end caps into the valve using an adjustable wrench.
Insert the valve into the piping and seal securely with a pex
conduit clamp.
Install the control box in an accessible place. Plug the
valve into the control box and then the control box
into the power outlet. Reopen the water inlet.
Make sure there is no air in the plumbing by opening a tap
at the highest point of the residence. If the bathtub has been left open, turn off the faucet once the water has started flowing again. Switch
on the circuit breakers. You can now install the sensors.
Sensors installation
Sensors should be installed at the lowest point of the floor to allow water to reach the
sensor. They must be securely fastened with the Velcro supplied and must never be
installed directly on concrete. A sticker to prevent contact with
concrete is provided in the box. Drill as close to water lines as
possible, making sure you do not damage them.
Fix the sensor in the hole. If you decide to cover the hole, use
a grid to allow water to flow to the sensor.
Remember to respect the locations you have numbered.
Remove the top plate from the dishwasher and
attach the sensor to the lowest level of the floor near
the water inlet. You can also order a sensor with a
detection wire for better protection.
Install the sensor on the back of the fridge near the water supply. Install the
sensor behind the toilet near the water supply line and the toilet bowl. Install
the sensor on the back of the washer under the water supply lines and the waste
water return.
If your water heater is protected
by a tank, install the sensor inside
the tank with a Velcro.
If your water heater is not protected
by a tank, install the sensor at the
lowest point of the floor making
sure to protect the sensor contacts
from the concrete
with the sticker
provided.
Repeat the steps according to the number of
places to protect relevant to your home.
Once all the sensors
are installed, stick the
inventory sheet
near the
control panel.
