User guide
886E - WIFI Version
6
Wifi connection
The 20-position Water-Protec system is equipped with a WiFi transmitter. You can choose to connect it to the Internet. This allows you
to view the status of your system from a secure portal and receive an email or a SMS notifications when a leak is detected. The portal
can be accessed from a cell phone, tablet or computer to remotely monitor system status.
To connect your system to the Internet, you must first allow the control pannel
to communicate on your Wi-Fi network. Press the
Reset
and
Cancel
buttons simultaneously for at least 10 seconds. When the 20
th
position
indicator light flashes, release both buttons and press
Cancel
.
LED 13
LED 14
LED 15
On
Off
Off
Access point server begin
Off
On
Off
Access point web site activated
Off
Off
On
Access point ready
On
Off
On
Access point should appear in a list of
Wi-Fi networks.
On your computer or mobile device, make sure the Wifi Transmitter is enabled and connect
it to the newly created network :
WP886E_AP
. Enter the password
waterprot886
.
Once connected, open a web browser and visit the address
192.168.4.1.
Check that the 16 characters on the screen correspond to the 16 characters of the serial
number of your control panel. This serial number is located behind the door of the battery
case.
Enter the name of your personal Wifi network and its password in the appropriate fields and
press “
Send
”. The control panel will restart. If the information entered is correct, the panel will
now be connected to the Internet.
If the data has been successfully accepted, this message will display:
“Included:
saved to EEPROM
... Water-Protect is about to reboot.”
If an error has been found, the following message will appear:
“Error: Name or Password” - The device cannot identify the name and password of the Wi-Fi
client entered. It is the responsibility of the user to provide the correct name and password of
their Wi-Fi network.
Account synchronization
In your Web browser, follow the steps to create your account.
Once your account is created, link your valve by entering the 16 characters of
your serial number.
Congratulations!
You have installed your Water-Protec water damage protection system.
Welcome to
mywp.water-protec.com/mywp