11
to the Dispensing Faucet. Route to the tubing
to the Drain Clamp and trim to length.
NOTE:
When cutting the polytubing make
clean, square cuts, failing to do so could
result in poor con nec tions and possible leaks.
CAUTION:
The lowest point of the line
should be the point of connection to the Drain
Clamp. There should be no sag in the line as
this may cause ex ces sive noise as the reject
water is fl owing to drain.
•Refer to Fig. 4, page 12. Insert the tubing
into the Drain Clamp. Make sure the
tubing is pressed all the way in to create a
pressure tight connection.
NOTE: If you want to pull the tubing out for
some reason, push the ring around the
tubing in and pull the tubing out.
D. R.O. Manifold Assembly Installation
Locate the site per Sec. III, C.3, page 7. Various
in stal la tion sites will require different types
of mount ing fasteners; be sure the fastener
selected will provide a fi rm, solid mounting.
A support panel may be necessary on thin
cabinet walls or to span between wall studs on
par ti cle board or drywall.
Do not drill through exterior cabinet walls or
leave sharp wood screw points exposed in
readily accessible cabinet interiors.
The close proximity of a dishwasher or a trash
compactor may require spe cial fabrication of a
mounting plate.
1. The mounting bracket will accept either #10
or #12 (5mm) mounting screws spaced on
6" (15 cm) centers. Allow at least 4" (10 cm)
of clearance beneath the fi lter housings to
accommodate fi lter changes. Mark the two
locations (the bracket can be used as a
template). Install the screws and tighten them
until the heads are about
5
/
8
" from the wall.
2. Locate the ¼" Red Feed Water Tubing.
Remove the red plug from the fi tting labelled
“In” on the manifold and insert the tubing.
Reference the special supplement sheet in
the carton for proper connection of all tubing
and removal of plugs. Run the tubing along
its course to the Feed Water Saddle Valve,
trim to length. (Refer to Fig. 1, page 5.)
Refer to Fig. 3,. To the end of the red
polytube install the Compression Nut, the
Plastic Ferrule, and the Insert. Connect to the
Feed Water Saddle Valve.
3. Locate the ¼" Black Drain Tubing connected
to the Dispensing Faucet. Remove the black
plug from the fi tting labelled “Drain” on the
manifold and insert the tubing. The end of the
Black Drain Tubing that should be inserted
into the “Drain” port will have a blue drain
restrictor in it. If tubing needs to be trimmed
Cold Water
Line
Saddle
Valve
Handle
Insert
Plastic
Ferrule
Red Tubing To
Manifold
Inlet
Compression
Nut
Tightening
Screw
Reversible
Back Plate
FEED WATER SADDLE VALVE
Figure 3
Summary of Contents for ECLIPSE WRO-35
Page 20: ...20 NOTES...
Page 23: ......
