Water Right ECLIPSE WRO-35, Installation, Operation & Service Manual

12

3/8" DRAIN CLAMP ASSEMBLY

to length, carefully slit ¼" Black Drain Tubing 
end that has the blue drain restrictor in it 
being careful not to damage the hose barb 
on the drain restrictor. Remove restrictor from 
tubing, make a square cut, and reinsert the 
drain restrictor. Allow the tubing to relax, then 
press drain restrictor fi rmly again to insure 
proper seating.

4.  Locate the ¼" yellow tubing with the tee 

attached to one end. Remove the yellow plug 
from the fi tting labelled "Out" on the manifold 
and insert the tubing.

5.  Locate the 

3

/

8

" Blue Product Water Tubing 

attached to the Dispensing Faucet. Firmly 
press one end into the tee. (Refer to Fig. 
1, page 5.) The fi ttings will grab the tubing 
and seal it in place. Make sure the tub ing is 
pressed all the way in to create a pressure 
tight connection. 

NOTE:

 If you want to pull the tubing out 

for some reason, push the ring around the 
tubing in and pull the tubing out. 

6.   Hang the Manifold Assembly on the 

mounting screws and tighten. DO NOT 
OVERTIGHTEN.

7.  Remove the wrap 

ping from the 

In–Line Activated Carbon Post Filter. Slice 
the 

3

/

8

" Blue Polytube where it would be 

convenient to install and change the In–Line 
Fil ter. Make a clean straight cut to insure 
proper connections. The “Out” port on the 
In–Line Filter should be towards the faucet. 
Firmly press in the tubing. The fi ttings will 
grab the tubing and hold and seal it in place. 
Make sure the tubing is pressed all the way 
in to create a pressure tight connection.

E.   Position the Drinking Water Hold ing Tank  and 

Make the Final Hose Connections. 

1.   Check the tank precharge pressure. Make 

sure it is between 5 to 7 psig. If not, use a 
bicycle hand pump or other pump to bring the 
pressure up to the 5 to 7 psig range.

2.   Pull the cap/plug off the top of the tank where 

the Tank Shut–Off should go. (Refer to Fig. 1, 
page 5.)

3.  Wrap the white Tefl on tape, included in the 

box, three times around the ¼" male outlet 
thread. Wrap in the direction of the threads 
(clockwise when looking down on the Holding 
Tank). The tape will act as a thread sealant. 
Screw on the Holding Tank Shut–Off Valve.

4.  Locate the 

3

/

8

" Yellow Tubing. Firmly press 

one end into the Holding Tank Shut–Off Valve 
and the other end into the tee. (Refer to Fig. 
1, page 5.) The fi ttings will grab the tubing 

Figure 4

Drain Clamp
Front Plate

Drain Pipe

1/4" Nut

1/4" Screw

Drain Clamp
Back Plate

Black Drain Tubing