Water Right ECLIPSE WRO-35, Installation, Operation & Service Manual

3

SECTION I.      INTRODUCTION 

   Your new Reverse Osmosis (R.O.) Drinking Water 

System uses a combination of fi ltration tech nol o gies 
to reduce unwanted contaminants in a water supply. 
The following steps combine to give you the best in 
clear sparkling drinking water: 

MECHANICAL FILTRATION/ACTIVATED 
CARBON

–The Sediment/Carbon Module will 

remove the larger particles such as silt, rust 
and scale. Its 5 micron (equal to 0.0002 inch) 
nominal rating helps to give maximum life to the 
R.O. Membrane. The activated carbon in the 
Prefi lter will remove any chlo rine that may be 
present in the feed water. This pre treat ment is 
also necessary for membrane protection.

REVERSE OSMOSIS MEMBRANE

–The R.O. 

Membrane is the heart of the fi l tra tion system. 
It is designed to reduce the dis solved min er al 
content of the water. Minerals picked up in the 
environment by the water are measured as Total 
Dissolved Solids (TDS). In the Reverse Os mo sis 
process, dissolved minerals are sep a rat ed from 
the incoming water (Feed Water) to produce 
the product wa ter (the Permeate). The excess 
minerals are rinsed to drain (the Reject Water). 

    The membrane is a specially con struct ed, fully 

aromatic polyamide fi lm, and is classifi ed as a 
Thin Film Composite (T.F.C.).

    The spiral wound construction of the R.O. 

Membrane provides maximum surface area 
for water production and is less susceptible 
to fouling by par tic u late matter, turbidity and 
colloidal ma te ri als. 

ACTIVATED CARBON

–The Ac ti vat ed Carbon 

Module contains carbon particles with a vast 
network of pores. The tremendous surface 
area of these pores (typically 800–1200 square 
meters per gram of carbon) gives the carbon 

very good adsorptive sites for sub stanc es that 
contribute to tastes and odors. 

IN–LINE ACTIVATED CARBON POST FILTER

–

The In–Line Activated Carbon Post Filter is 
located after the Holding Tank and reduces the 
tastes and odors that may pass through the 
system. It adds a fi  nal polish to the water. 

AUTOMATIC SHUTOFF VALVE

–The ASO Valve 

senses when the Holding Tank is full and closes 
the feed water supply to prevent excess reject 
water from going to drain when the unit is not 
producing water.

WATER QUALITY MONITOR

–The Water Quality 

Monitor has been integrated into the faucet 
base for instant monitoring at the touch of a 
button. The monitor compares the level of the 
Total Dissolved Solids in the incoming (feed) 
water versus the product water and calculates 
the percent rejection. The monitor is preset to 
indicate a level of 75% rejection. 

     A green light indicates that the percent rejection 

is at or above the set (desired) value and that 
the system is producing quality water. 

     An amber light indicates that the product water 

quality is less than acceptable. Because the 
Water Quality Monitor was designed to operate 
best while the system is making water, a false 
reading may occur if tested when your R.O. 
drinking water system is not making water. 
Please empty the Holding Tank, wait 15 minutes 
for the system to begin making water, and test 
your water quality again. If the Water Quality 
Monitor light is still amber, please contact a 
water treatment professional for service. The 
Water Quality Monitor requires a 9 volt battery, 
which is included.

IMPORTANT NOTICES:

This reverse osmosis system contains replaceable treatment components critical for effective performance. It is the user's 
responsibility to, and the manufacturer strongly recommends that the user, periodically test the product water to verify the 
system is performing satisfactorily. See the test kit(s) for sampling instructions.

This system is acceptable for treatment of infl uent concentrations of no more than 27 mg/l nitrate and 3 mg/l nitrite in 
combination measured as N and is certifi ed for nitrate/nitrite reduction only for water supplies with a pressure of 40 psig 
(280 kPa) or greater. 

This system conforms to NSF/ANSI Standard 58 for pentavalent arsenic reduction. See the Performance Data Sheet and 
Arsenic Facts section for an explanation of reduction performance.

DO NOT USE WITH WATER THAT IS MICROBIOLOGICALLY UNSAFE OR OF UNKNOWN QUALITY, WITHOUT 
ADEQUATE DISINFECTION BEFORE OR AFTER THE SYSTEM.

 Systems certifi ed for cyst reduction may be used on 

disinfected water that may contain fi lterable cysts.