Water Right ECLIPSE WRO-35, Installation, Operation & Service Manual

5

SECTION III.    PREPARATION 

A.  Major System Components 

    The following components comprise the R.O. 

Drinking Water System. (Refer to Fig. 1, below  
for general system layout.)

•    An R.O. Manifold assembly.

•    Housings and Housing O–rings.

•    A Drinking Water Holding Tank.

•    A Dispensing Faucet with Water Quality 

Monitor Assembly.

•    A Feed Water Saddle Valve.

•    A Drain Clamp.

•    Plastic Tubing and tube connectors.

•    A Reverse Osmosis Mem brane sealed in a 

plastic bag.

•    A Sediment/Carbon Module, shrink wrapped.

•    An Activated Carbon Module, shrink 

wrapped. 

•    An In–Line Activated Carbon Post Filter, 

shrink wrapped. 

•    Other items necessary for installation may 

include wood screws or machine screws and 
nuts for mounting the manifold, or concrete 
anchors for hanging on basement wall. 
Additional tubing or tube connectors. Plastic 
wire ties for organizing tubing. 

TYPICAL WRO-35 UNDER SINK INSTALLATION DIAGRAM 

Figure 1

DISPENSING
FAUCET WITH
AIR GAP

1

DRAIN

(1/4" Black)

COVER

IN-LINE
ACTIVATED
CARBON
POST FILTER

DRAIN

(3/8" Black)

PRODUCT

(3/8" Blue)

INLET

(1/4" Red)

ACTIVATED
CARBON
MODULE

REVERSE
OSMOSIS
MEMBRANE
HOUSING

(1/4" Yellow)

SEDIMENT/
CARBON
MODULE

SADDLE VALVE
(COLD WATER LINE ONLY)

RO MANIFOLD

DRAIN
CLAMP

HOLDING TANK

SHUTOFF VALVE

(Open Position)

DRINKING

WATER

HOLDING

TANK

LOCATE DRAIN CLAMP ABOVE

"P" TRAP

TANK

(3/8" Yellow)

POLYTUBE
TEE

NITRATE/NITRITE

TEST KIT

11

10

9

7

6

5

4

3

2

8

4" MIN.

WATER QUALITY
MONITOR
FAUCET BASE

WATER QUALITY
MONITOR CABLE