Setup
Unpacking and Inspection
Check the
Fleet Farm Water Treatment
system components for damage or missing parts.
Where to Install the Softener
Consider the following points when determining where to install the water softener:
•
Place the
Fleet Farm Water Treatment
system as close as possible to a sewer drain.
•
Do not install the softener where it would block access to the water heater, or access to the main water shutoff,
water meter, or electrical panels.
•
Keep outside faucets on hard water to save soft water and salt.
•
Install the softener in a place where water damage is least likely to occur if a leak develops.
•
A 120V electrical outlet is needed to plug in the transformer. If the outlet is remote (up to 100 feet), use 18 gauge
wire to connect.
•
Always connect the
Fleet Farm Water Treatment
system to the main water supply pipe before the water heater.
•
If using well water, always install the
Fleet Farm Water Treatment
system after the pressure tank, but before the
water heater.
•
Install the
Fleet Farm Water Treatment
system where it will not be subject to temperatures outside of the limits
stated in the Specification section or to direct sunlight.
Hardness Setting
Municipal Water
Fleet Farm
recommends that you bring in a sample of water in to be tested. Fleet Farm personnel will test your water
free of charge. Or call your local water company to determine your water hardness in grains per gallon and iron in
mg/l (or ppm).
Well Water
Again,
Fleet Farm
recommends you bring a sample to the store to be tested or have your water tested professionally
for accurate hardness and iron content.
Installation
1. Turn off gas or electric supply to the water heater.
2. Turn off the water supply to pipes to be cut and drain the house water pipes.
3. Open both hot and cold faucets.
4. Move the softener assembly into installation position.
•
Be sure the installation surface is level and smooth.
•
Provisions should be made to by pass outside faucets.
5. Plumb IN and OUT connections to and from softener.
Summary of Contents for FF-948-M
Page 19: ......
