Figure 3
Use Step 10 to install rigid drain pipe.
10. To adapt a rigid drain pipe to the
Fleet Farm Water Treatment
system, unscrew the attached barbed hose fitting to
valve. Instead, plumb rigid tubing directly to the 1/2" male NPT drain fitting.
Figure 4
11. Take the other half of the cut hose and attach it to the overflow adapter elbow located on the side of the brine
tank. Use a hose clamp to hold it in place. Locate the other end of the hose at the drain point as shown in Figure
3.
12. Fully open two (2) cold (soft) water faucets near the water softener.
A – Hose barb from valve
B – Overflow hose off of brine tank
C – Valve drain hose
A
B
A - 1/2” female NPT drain outlet
B -
Rigid drain pipe
Summary of Contents for FF-948-M
Page 19: ......